1. Preparation

Make sure the surface is level. For concrete, fill in damaged areas. For wood, replace old, warped boards.

Thoroughly clean the surface where the pavers will be placed. Allow time for the surface to completely dry. This will ensure the best adhesion.

2. Paver Layout

Place Dutch Pavers on the surface to ensure you have enough pavers and that you like the layout.

Suggested Layouts:

Center

1. Determine the center of the area you want to cover.

2. Snap a chalk line horizontally and vertically through the center at a 90° angle from each other.

3. Install 4 Dutch Pavers, each with a corner touching the center point. Use the lines as a guide, and move out from the center point diagonally.

4. Repeat until all quadrants are full.

Suggested Layouts continued...

Corner

1. Choose the corner you would like to start at.

2. Snap a chalk line vertically and horizontally from this point. These lines should be at a 90 degree angle to each other. Lines should be at least 2 pavers wide.

3. Install 4 Dutch Pavers snugly in corner.

4. Following lines, add Dutch Pavers in each direction.

5. Repeat until all quadrants are full.

Cutting Pavers

1. Measure the area.

2. Mark measurement on Dutch Paver.

3. Use a razor knife to make a series of score to achieve a clean edge.

4. When possible, keep the cut edges against a vertical surface.

3. Installation

1. Begin installation based on the layout you chose.

2. Apply a polyurethane adhesive to the bottom of the paver.

3. Place paver on surface.

4. Tap pavers into place with a rubber mallet.

5. Continue until all pavers are in place.

6. Allow area to dry for 24 hours before use.